Wittkopp SmartCam - Operation Mode K3; Locking K3; Opening K3 with User Code; Changing Master;Facility-Master Code K3

12
SmartCam
7 Operating/programming operation mode K3
7.1 Locking K3
At any time upon locking a 4-/6-digit user code can be chosen.
 
1. Close the door at the safe and turn the knob into locking position.
2. Enter your 4-/6-digit code e.g. user code. The lock is closed.
3333
/
33
• The locking process can be done backwards.
7.2 Opening K3
7.2.1 Opening with user code K3
 
1. Enter your 4-/6-digit previously selected 4-digit user code e.g.
3333
/
33
2.
Turn the knob within 3 seconds into opening position.
The lock is opened.
7.2.2 Opening with master code/facility-master code K3
By entering the master code the user code will be deleted.
When entering the facility-master code the user codes stay valid. The lock has to be closed by pressing a
button afterwards.
 
1.
Press and hold the key “8“ for approx. 3 seconds.
When releasing the key the green LED lights up permanently.
8
2.
Enter your 6-digit master code/facility-master code e.g.
123456
3.
Turn the knob within 3 seconds into opening position.
The lock is opened.
• After a wrong code input a long signal tone occurs and the red LED flashes.
• After 4 consecutive wrong code inputs, a blocking time of 1 minute occurs. During this blocking time the red LED flashes
every 10 seconds. It is not possible to insert a code during the blocking time is active. After the blocking time expires the red
LED stops flashing. After the blocking time has passed 2 further incorrect inputs will restart the blocking time of 1 minute.
7.3 Changing the master code/facility-master code K3
Changing the master code is only possible when the lock is opened.
 
1.
Press and hold the key “2“ for approx. 3 seconds.
When releasing the key the green LED lights up permanently.
2
2. Enter your 6-digit code e.g. master code.
123456
3. Enter your new 6-digit code e.g.
101010
4. Re-enter your new 6-digit code e.g.
101010
5. The new code is accepted.