Stir one measuring cap WMF milk system cleaner into 200 ml lukewarm water in a container >
Place all parts of the milk system > [8] in the cleaning solution for 5 hours or overnight [9]
> Then rinse all parts thoroughly with running warm water [10]
Reassemble the milk foamer > [11] [12], noting the labelling, pin and hole
Insert the milk nozzle in the milk hose
>
Replace the milk hose on the milk foamer > [13]
Push the milk foamer into the All‑in‑One professional spout from below and engage
>
the latch [14] [15]
Move the All‑in‑One professional spout to the lowest position > [16]
Insert the milk hose into the guide
> [16]
With the brushes included in the scope
of delivery, you can clean the narrow
beverage spouts optimally.
See
“Accessories and spare parts” chapter.
8 9 10
11 12 13
14 15 16
To Next Page
Loading...
