Clean the brewing filter under running water or with a cloth > [7]
Rinse the brewing unit under running water
> [7]
Never clean the brewing unit in a dishwasher and never use any cleaner additives.
Dry the brewing unit with a cloth. Allow to dry completely before replacing in the coffee machine
>
Remove coffee grounds in the chute with a vacuum cleaner > [8]
Replace the tray for coffee grounds
> [9]
Check the O‑rings for contamination and damage
> [7] [10]
Screw the brewing unit back on clockwise using the multitool until the scraper closes again
>
Refit the brewing unit after it has been dried.
Insert the brewing unit and push it firmly back into the housing until the handle (marked “PRESS”)
>
snaps in clearly and is level again [11]
Close the side door
>
If the brewing unit cannot be inserted completely:
Turn thread on the brewing unit head slightly to the left or right with the multitool until
the brewing unit slides into the guide. Never use force!
7 8 9
10 11
To Next Page
Loading...
