WMF 1200 S - Page 74

74
User Manual WMF1200 S
Care
Rinsing
Rinsing starts. Duration approx. 22minutes.
 When requested, fill with clean, cold drinking water
(after about 11minutes)
 Empty collection container
 Empty water tank
 Replace the water filter, if fitted
 Insert the water tank
If awater filter is used, amessage appears after the
process is complete, with arequest to re-install the
water filter.
 Place the water filter
 Fill the water tank with clean cold drinking water
The water filter is rinsed briefly.
Burn hazard
• After the final rinsing the steam boiler
is heated up. The hot water expands and
finally exits briefly as steam.
> Do not reach beneath the spouts while
descaling is in progress.
> Do not touch the spouts immediately after
descaling.
As soon as the descaling procedure is finished, the
“Ready to operate” display appears.
 Remove the collection container
 Re-install the milk hose
CAUTION
Follow the Safety chapter
w starting on page 6
your selection pls
08:15 09.01.2013
DI_00_00_00