Wolf BM-Solar - Display Values - Descriptions (A:13-A:18); Display Values A:13-A:16; Display Values A:17-A:18

12 3061916_0611
SM1/ Theyieldforthecurrentdayisdisplayed.Thisvalue
SM2: isonlyavailableifareturnsensor,aheatmetersetoran
externalheatmeterhasbeenconnectedtotheassociated
SMsolarmodule,andvalue1,2,3or4hasbeenselected
forparameter08.Inaddition,afurther BMprogramming
modulewithaddress0oraradioclockreceiver(accessory)
mustbeinstalledintheoverallsystem.
Thisvaluecanberesetto0bypressingandholdingdownthe
rotaryselectorforatleast10seconds.
A : 1 3
Currentdayyield
SM1/ Thesethreedisplaysshowtheentireyieldachieved
SM2: bythesolarthermalsystem.Thevalueiscomposedofthe
threevaluesthataredisplayed.
Example:A14=350,A15=12,A16=0
→Totalyield=350Wh+12kWh+0MWh=12.35kWh
Thesevaluescanberesetto0bypressingandholdingdownthe
rotaryselectorforatleast10seconds.
Thesevaluesareonlyavailableifareturnsensor,aheatmeterset
oranexternalheatmeterhasbeenconnectedtotheassociated
SMsolarmodule,andvalue1,2,3or4hasbeenselectedfor
parameter08.
A : 1 4
TotalyieldinWh
A : 1 6
TotalyieldinMWh
A : 1 5
TotalyieldinkWh
SM1: Thisindicateswhetherasolarheatingprocesshasbeen
completedsuccessfullywithinthelast24hours.
SM2: Thisindicateswhethersolarheatingofcylinder1hasbeen
completedsuccessfullywithinthelast24hours.
This applies if, within 24 hours prior to 14:00 h, the set DHW
temperatureselectedattheheatingappliancewasexceededby
solarheating.
Inthatcase,thesetDHWtemperatureattheheatingappliance
willbesettotheminimumcylindertemperature(cylinderreheating
blocked).
Thisfunctionisonlyavailableifthesolarmoduleisoperatedas
partofaWolfcontrolsystem(forafunctiondescription,seethe
SMsolarmodulemanual).
A : 1 7
SM1: Solarheatingstatus
SM2: Solarheatingstatus
Cylinder1
A : 1 8
SM1: Notinstalled
SM2: Thisindicateswhethersolarheatingofcylinder2hasbeen
completedsuccessfullywithinthelast24hours.
This applies if, within 24 hours prior to 14:00 h, the set
DHWtemperatureselectedattheheatingappliancewasexceeded
bysolarheating.
Inthiscase,thesetDHWtemperatureattheheatingappliance
willbesettotheminimumcylindertemperature(cylinderreheating
blocked).
Thisfunctionisonlyavailableifthesolarmoduleisoperatedas
partofaWolfcontrolsystem(forafunctiondescription,seethe
SMsolarmodulemanual).
SM1: Notinstalled
SM2: Solarheatingstatus
Cylinder2
Display level