Need help?Do you have a question about the Wolf LH and is the answer not in the manual?
General| Frequency | 50Hz |
|---|---|
| Power Output | 2000W |
| Voltage | 230V |
| Thermostat | Yes |
| Safety Features | Overheat protection |
Provides general context and applicability of the instructions.
Explains symbols used for safety and technical reliability in the instructions.
Details essential safety precautions for installation, operation, and maintenance.
Lists applicable standards and regulations for LH unit heaters.
Describes the construction and components of the Wolf LH unit heaters.
Covers installation and operation specifics for heat exchangers and electric heaters.
Addresses ceiling-mounted units and motor operation for LH heaters.
Specifies required clearances for LH ceiling and wall units in metres.
Table detailing discharge accessories based on spacing for LH units.
Provides mounting data and air throw performance for different unit types.
Details suspension angles, mounting brackets, and fixing methods for LH units.
Describes kits for securing LH units to concrete or steel bars.
Covers inclined and horizontal fastening kits for steel bars.
Electrical connection diagrams and information for three-phase motors.
Electrical connection diagrams for single-phase AC motors.
Details on D1 and DS switches for unit heater speed control.
Details on D 5 and E 5-3 five-step switches for multi-speed operation.
Information on E3-7T and D 3-4 three-stage switches for 3-speed operation.
Auxiliary relay for automatic fresh air damper operation (Open-Shut).
Relay with position transmitter for automatic mixed air damper operation.
Details various room thermostats and their specifications.
Information on the anti-frost thermostat and its wiring.
Overview of BML modules, LM1/LM2 units, sensors, and clocks.
Example and installation diagram for LM1 with BML module.
Example and installation diagram for LM1/LM2 with BML.
Example and diagram for LM2 with electronic speed regulator.
Details on OPEN-SHUT and stepless actuators for dampers and louvres.
Describes push-button control for induction louvres.
Diagrams for wiring multiple LH units with intermediate terminal boxes.
Guidelines for cleaning heat exchangers, filters, and other components.
Instructions for draining units and protecting against frost.
Demonstrates hydraulic adjustment using individual control valves.
Shows hydraulic adjustment using the Tichelmann pipework system.
Methods for installing and sealing rain protection hoods and roof lead-in boxes.
Describes flexible and non-flexible connection methods for roof installations.
Provides additional notes and remarks for the user.
To Next Page