3
Cooling
1. Introduction
Glossary of terms
The following abbreviations and terms are used thorough the document and refer to the following:
BFC Beermaster Free Cooler
BMIEP Beermaster Indoor Evaporator Plus (also referred to as the evaporator)
BMOP Beermaster Outdoor Plus (also referred to as the Condensing Unit
FLC Full Load Current
HP High Pressure
LP Low Pressure
LRA Locked Rotor Amps
MCB Motor Circuit Breaker
PCB Printed Circuit Board
PPE Personal Protective Equipment
PRV Pressure Relief Valve
SWA Steel Wire Armoured (used to refer to steel wire armored cable)
TD Temperature Difference
TEV Thermal Expansion Valve
Health and safety
This document has been designed to help you and make the installation easier. Please read the points below to be familiar
with the units and the installation. This manual contains information on hazards that may be encountered when installing and
maintaining the equipment. It is therefore important that these instructions are followed. Upon receipt, the units should be
visually inspected, and the supplier notified of any damage or shortages within seven days from receipt of the unit. Care must
be taken when removing the packaging and during installation, to prevent the finished surfaces being damaged. Units are not
portable and are only for permanent installation.
CAUTION
All work on the unit must be carried out by qualified personnel only. The installation and maintenance manual
must always be kept with the unit. Ensure that the instruction manual is understood before installation. Ensure
working environment is suitable and any additional hazards caused or increased by the environment are given
appropriate consideration.
Use suitable PPE as per site regulations and as appropriate for the task. It is the responsibility of the person performing the task
and their employer to ensure that all necessary PPE is provided and worn. Detailed below is some of the suggested PPE that may
be required during installation and commissioning of the unit.
Head protection Foot protection Hand protection Eye protection
Before installation
Ensure that:
1. The voltage, working fluid and the maximum working pressures stated on the product nameplates are suitable for the
proposed working environment.
2. The units are to be operated solely for cellar type cooling applications and will be put into operation as per this manual.
3. The proposed method of mounting is adequate to support the total operational weight of the unit (including refrigerant
charge), which can be found on the unit nameplate.
4. The working environment is safe and suitable for the work required to install the product.
To Next Page
Loading...