Safety & General Information
Cutting Capacity
1
1-16 15doc091818 Safety & General Information
1.8 Cutting Capacity
See Table 1-4. The log size capacities of the LT15 sawmills are listed below.
1.9 Engine/Motor Specifications
See Table 1-5. The power options available for the LT15 sawmill are listed below.
1.10 Noise Level
See Table 1-6. The average level of noise is given in the table below
12
.
Max. Diameter
Max. Length
1
1
Each additional bed frame segment adds approximately
195 cm ( 6’ 5” ) to the length capacity.
LT15 S3 70 cm 5.4 m
LT15 S2 70 cm 3.5 m
LT15 M2 70 cm 5.2 m
LT15 M3 70 cm 7.9 m
TABLE 1-4
Engine/Motor Type Manufacturer Model No. Specifications
18HP Gasoline Kohler CH18
624 ccm, 3600
min
-1
10HP Diesel Engine Yanmar, Japan L100
406 ccm, 3600
min
-1
TABLE 1-5
Sawmill Noise Level
LT15E11 81,9 dB (A)
LT15G18 89,7 dB (A)
LT15D10 87,0 dB (A)
TABLE 1-6
1. The noise level measurement was taken in accordance with PN-EN ISO 3746 Standard. The noise exposure level
given above concerns an 8-hour work day.Value for associated uncertainty K=4dB.
2. The figures quoted are emission levels and are not necessarily safe working levels. Whilst there is a correlation
between the emission and exposure levels, this cannot be used reliably to determine whether or not further precautions
are required. Factors that influence the actual level of exposure of the workforce include the characteristics of the
work room and the other sources of noise etc. i.e. the number of machines and other adjacent processes. Also the
permissible exposure level can vary from country to country. This information, however, will enable the user of the
machine to make a better evaluation of the hazard and risk.
To Next Page
Loading...
