Trailer Installation
Unassembled Sawmill
Trailer Installation 1510doc111714 1-3
1
1.2 Unassembled Sawmill
If you are adding the LT15TRG trailer option to a new unassembled LT15 sawmill, the
sawmill bed can be assembled to the trailer frame. Be sure to use adequate manpower
and lifting equipment to safely lift and stabilize the sawmill during installation.
1. Lower the trailer outriggers and use the jack handle to adjust the outriggers to lift the
trailer weight off the wheels and to level the trailer frame.
2. Disengage the trailer fender locking straps and lift the fenders from the trailer.
3. Lift the trailer winch assembly and pivot the winch down to the ground.
4. Pivot the saw head rest bracket down.
5. Position the sawmill bed sections onto the trailer frame with the track position on the left
side of the trailer as viewed from the hitch end. Connect the bed sections as described in
the LT15 manual. Align the leg mounting holes with the holes in the trailer frame and
secure the bed to the trailer frame with the provided mounting bolts, bushings, washers
and nuts.
See Figure 1-3.
6. Refer to the LT15 manual to complete sawmill assembly and setup (skip the feed rope
installation until trailer installation is complete).
FIG. 1-3
3
150193-3
4
Adjust outriggers
to level trailer
frame
Jack
handle
½-13 x 6 ½” Hex
Head Bolt (6)
Bushing (8)
½-13 Hex
Nylon Lock
Nut (8)
½-13 x 3 ½” Hex
Head Bolt (2)
Pivot rest
bracket down
Lift and pivot
winch to ground
Lift fenders
from trailer
Washer (8)
Place bed sections
on trailer frame, connect
and secure with
provided hardware
To Next Page
Loading...
