Safety
Multi-Planer Operation
2
2-4 EGdoc052521 Safety
do not engage rotating members resulting in possible injury.
WARNING! Beware of rotating parts. Shut down the machine and
allow all moving parts to come to a complete stop before removing any
guards and covers. Do NOT operate the Multi-Planer with any guards
or covers removed.
DANGER! Before changing the knives or performing any service to the
machine, disconnect the power cord from the electric box.
IMPORTANT! The knife and feed assembly covers are equipped with
limit switches. After opening the cover, the motor will turn off and all
moving parts will stop. The limit switches should always be in proper
working condition.
Multi-Planer Operation
CAUTION! The workplace should always be well illuminated.
The illuminance at the operator's position should be at least 300lx.
Never use the Multi-Planer under the influence of strong medication,
alcohol or drugs.
WARNING! Make sure the knives are properly fastened before starting
the motor.
WARNING! Never place tools or hands in the infeed or outfeed areas
when the Multi-Planer is running.
IMPORTANT! When starting the machine for the first time, check that
the main motor rotation direction is as indicated by the arrow located
on the motor body (fan guard). If the rotation direction is incorrect,
invert the phases in the phase inverter in the power socket (electrical
box). Setting the phases in the phase inverter correctly will ensure
correct rotation directions of all motors.
DANGER! Always measure the workpiece and set suitable thickness
and width before planing. There is a risk of accident if you feed in a
workpiece that is not high enough for the feed rollers to get hold of it.
When planing smaller material, it should be stiffened/extended, e.g.
with a longer piece of wood.
To Next Page
Loading...
