Safety
Multi-Planer Operation
Safety EGdoc052521 2-5
2
Never stand in front of the material being fed or received, because it
may kickback suddenly towards the operator. This applies to both the
infeed and outfeed sides, although the risk is higher on the infeed side.
DANGER! Planing/moulding is possible only in the direction shown
below. The arrow “A” indicates the planing direction on the upper table.
The arrow “B” indicates the planing direction on the lower table. Never
try to perform planing/moulding in the opposite direction!
DANGER! When planing on the upper table, use the pusher “C”
provided with the machine. It is not allowed to push the material by
hand!
Use proper maintenance procedures.
DANGER! Make sure all electrical installation, service and/or
maintenance work is performed by a qualified electrician and in
accordance with applicable electrical codes.
DANGER! Hazardous voltage inside the electric boxes and at the
motor can cause shock, burns, or death. Disconnect and lock out
power supply before servicing! Keep all electrical component covers
closed and securely fastened during machine operation.
FIG. 2-1
To Next Page
Loading...
