SETUP & OPERATION
Multi-Planer Setup
EGdoc052521 3-3
3
See figure 3-2.
Mount the upper outfeed table using M8x25 socket head screws (A). Tighten the screws firmly.
The adjusting screws (B) are factory-set and do not need to be adjusted.
WARNING The outfeed table must be handled by two adult persons.
Use safety boots and gloves when handling!
See figure 3-3.
Check that no tools have been left in the planer.
Check that the cutters can rotate freely before the safety doors are closed.
FIG. 3-2
FIG. 3-3
To Next Page
Loading...
