Setup and Operation
One-person operation
Setup and Operation doc061821 3-3
3
See Figure 3-1.
7. Remove the pass back bars from the table top by unpinning them and slide them out.
8. Momentarily (approximately 15 seconds) run the blade on the drive wheels.
9. Turn off disconnect.
10. Open the wheel covers to inspect the blade tracking.
NOTE: If the blade is not tracking in the center of the tire, refer to
Section 4.2 Tracking the blade.
11. When the blade is tracking properly, close the wheel covers and turn on the disconnect.
12. Start the blade.
See Figure 3-2.
13. Use the air valve to adjust the table approximately one board thickness plus 1/4 inch (6
mm) below the blade.
Air valve controls: Neutral is the 3 o’clock position. Raise the han-
dle up to raise the table; lower handle to lower table. Always return
the handle to the neutral position.
14. Place half the pallet over the blade and lower the pallet so the blade is positioned
between two deck boards. (See figure
3-2.)
FIG. 3-1
FIG. 3-2
Tension ratchet
handle
Stop bolt
To Next Page
Loading...
