Setup and Operation
Two-person operation
Setup and Operation doc061821 3-5
3
NOTE: If the blade is not tracking in the center of the tire, refer to
Section 4.2 Tracking the blade.
5. When the blade is tracking properly, close the wheel covers and turn on the power.
See Figure 3-4.
6. Use the air valve to adjust the table approximately one board thickness plus1/4 inch (6
mm) below the blade.
Air valve controls: Neutral is the 3 o’clock position. Raise the han-
dle up to raise the table; lower handle to lower table. Always return
the handle to the neutral position.
7. Operator 1: Place the pallet on the table with the deck side down and against the fence.
8. Operator 1: Start the blade.
IMPORTANT! Only one person should have contact with the pallet
while cutting.
9. Operator 1: With the pallet at a slight angle to the blade, push the pallet half way through
the blade.(See Figure
3-4.)
DANGER! Keep hands 12” away from the blade. Failure to do so
will result in death or serious injury.
NOTE: Move the pallet from side-to-side as you push or pull to
ease the cut.
10. Operator 2: Pull the pallet completely through the blade.
11. Operator 2: Turn the pallet over and place it on the pass back bars.
12. Operator 1: Place the pallet on the table and against the fence.
13. Operator 1: With the pallet at a slight angle to the blade, push the pallet half way through
the blade.
14. Operator 2: Pull the pallet completely through the blade.
15. Either operator: Turn off blade.
FIG. 3-4
To Next Page
Loading...
