EGCP-2 Engine Generator Control Package Manual 26174
68 Woodward
Security Access
Security Code Required For Access
The EGCP-2 has built-in security to protect against configuration changes and
alarm purges by unauthorized personnel. There are five levels of access to the
configuration menus. They are listed below. Each successive level has access to
all of the levels above. A four-digit security code is required for access to the
configuration menus. If an incorrect code is entered, or a proper code is not
entered within 300 seconds, the displays will default to the last Status screen
selected.
Levels Of Access
Monitor (no security code)
Access to all Status Screens, view Alarm / Event Log Display, and ability to
commit (clear) an Audible Alarm.
Operator
Access to view and clear Alarm / Event Log and change the Network
Priority.
Supervisor
Allows access to change the Network Address and Time Setting (Clock).
Technician
Allows access to all set points except Engine Run Time and the Calibration
menu.
Factory
Full access, includes the Engine Run Time and the Calibration menu.
When the Config key on the EGCP-2 keypad is pressed, the right LCD screen
will switch to the configuration menus. A Security Code prompt will be provided
prior to access into the Configuration Menus. The Security Code value
determines which configuration menus are accessible and if the Alarm / Event
log can be cleared.
Figure 4-13. Security Code Display
To Next Page
Loading...
Need help?
General
