Woodward DTSC-200A - Page 4

Manual 37942A DTSC-200A - ATS Controller - Application
Page 4/21 © Woodward
Illustrations And Tables
Illustrations
Figure 2-1: Application mode - Util-Gen ............................................................................................................................................ 6
Figure 2-2: Application mode - Gen-Gen ........................................................................................................................................... 7
Figure 2-3: Application mode - Util-Util ............................................................................................................................................ 8
Figure 2-4: Example application - transfer delay (Util-Util) ............................................................................................................. 9
Figure 2-5: Example application – external permit closed transition ..............................................................................................10
Figure 2-6: Example application – LogicsManager .........................................................................................................................11
Figure 3-1: Limit switch reply wiring - "closed" replies only .........................................................................................................12
Figure 3-2: Limit switch reply wiring - all replies............................................................................................................................13
Figure 4-1: Gen-2-Gen application ....................................................................................................................................................14
Figure 5-1: Example - transition mode selection switch wiring ......................................................................................................16
Figure 5-2: Example - LogicsManager Delayed mode active .........................................................................................................16
Figure 5-3: Example - transition mode selection switch wiring ......................................................................................................17
Figure 5-4: Example - LogicsManager Extended parallel time .......................................................................................................17
Figure 5-5: Example - Shunt trip enable signal wiring ....................................................................................................................18
Figure 5-6: Example - LogicsManager Shunt trip enable signal .....................................................................................................18
Figure 5-7: Overlap time counter screen ...........................................................................................................................................20
Tables
Table 1-1: Manual - Overview ............................................................................................................................................................. 5