Worcester GR8700iW 35 C - Service Menu; Overview of the Service Menu

Settings in the service menu
Greenstar 8000 Style – 6720883864 (2019/02)
48
7.2 Service menu
7.2.1 Overview of the service menu
Benchmark
– Actual temp.
– DHW flow rate
– Hot water temp.
Info
– Current status
– Current fault
– Fault history
– Boiler
– Mx.heat.outp %
– Mx.heat.outp kW
– Actual temp.
– Set flow temp.
– Low-loss hdr.tmp
– Heating mod.
– Act. burner mod.
– Burner output
– Ionisation current
– Pump mod.
– Outside temp.
– HC1 pump
– Burner starts
– Hours run
– System pressure
–Hot water
– Max. outp.(kW)
– DHW flow rate
– DHW act. temp.
– Hot water temp.
– DHW set temp.
– Autom. filling
– System pressure
– No. of refills
– Last refill dur.
– Refilling active
–System
– Contr.device ver.
– Progr. unit ver.
– SW sub-ver.
– Code plug no.
– Code plug ver.
–Key
1)
– Solar
– Collector temp.
– Cyl.temp.bottom
– Collector pump
– Solar fault
Settings
– Hydraulics
– Low-loss header
– DHW configuration
– HC1 configuration
– Pump config.
– Heating
– Mx.heat.outp %
– Standby time
– Clock inh. T. off
– Clock inh. T. on
–Hot water
– Turbine signal del.
– DHW start del.
– Preheat
– Pump
– Pump range map
– Pump ctr. mode
– Min. output
– Max. output
– Pump overrun
– Min.syst.pressure
– Target pressure
– Special function
– Ventilation func.
– Siphon fill. prog.
– 3-WV mid. pos.
– Autom. filling
– Autom. filling
– Min. Sys. Pres.
– Target Sys. Pres.
– Max. refill time
– Blocking time
– Max. refills
– Reset refilling
– Maintenance
– Maintenance type
– Without
– Boiler run time
– Burner run time
– Service date
1)
– Landlord
1)
– End date
– Maint. reminder
– Installer tel. no.
– Limit values
– Max. flow temp.
– Max. DHW temp.
– Min. boiler outp.
– Heating curve
– Req. odr. temp.
– Htg. curve base
– Htg. curve end
– Summer mode
– Frost prot.
– Frost temp. limit
– Solar
– Max. solar temp.
– Solar pump type
– Start solar system
Function check
– Activate test
1) Only available with installed Key Timer (accessory)