24 | SHARPENING CUTTING TOOLS
NOTE: These tools usually have only one sharp, beveled blade. Re-sharpen ONLY the
beveled blade. These tools do not require sharpening to a precise angle; just let the
belt conform to the edge of the tool.
STEP 1
Clamp pruners in a bench vise.
STEP 2
Make 2 to 4 strokes or until you are
satisfied with the sharpness.
NOTE: Some tools require the anvil to
be inserted through the grinding frame
opening (as shown) to allow belt access
to the cutting edge.
SHARPENING CUTTING TOOLS
PRUNERS, SHEARS, & OTHER BYPASS CUTTING TOOLS
BELT ANGLE GUIDE EDGE GUIDE SPEED
RED P220 REMOVED* DOWN GRINDING (2)
* Pull up on the Angle Guide to remove from
the Sharpening Cassette.
SET UP
Rotate Sharpening Cassette into
the Grinding position.
To Next Page
Loading...
