SAFETY INFORMATION | 7
SAFETY GUIDELINES — DEFINITIONS
The label on your tool may include the following symbols.
V........................ Volt A ................ amperes
Hz......................Hertz W ................ watts
min ................... minutes
............ alternating current
................ direct current
n
o ............... no load speed
................... Class II Construction ............. earthing terminal
• ....................safety alert symbol min
-1
.......... revolutions or
.................................. reciprocations per minute
MOTOR
Be sure your power supply agrees with nameplate marking. 120 VAC Volts AC only means your tool will operate on
standard 60 Hz household power. Do not operate AC tools on DC. A rating of 120 volts AC means that your tool will
operate on standard 60 Hz AC power. This information is printed on the nameplate. Lower voltage will cause loss of
power and can result in over-heating.
INTENDED USES:
• Grinding, Sharpening and Honing applications on knives and tools
• Light duty grinding in metal
• Only for use with consumer use
• Tool should only be used with sharpening cassette installed
UNINTENDED USES:
• Industrial or commercial grinding or sharpening applications
• Extended, continuous heavy duty use beyond 30 minutes per hour
To Next Page
Loading...
