Cordless Grass Trimmer EN
9
TECHNICAL DATA
Type Designation: WG183E WG183E.9 (1-designation
of machinery, representative of Cordless Grass
Trimmer)
WG183E WG183E.9
Voltage 40 V MAX (2x20 V MAX) **
No Load Speed 6800 /min
Cutting
Diameter
33 cm
Line Diameter 1.65 mm
Line length 5 m (Dual-Exit)
Battery type Lithium-ion /
Battery Model WA3551.1(2.0 Ah) /
Charger Model WA3772 /
Charger rating
Input: 100-240 V~50/60
Hz , 50 W
Output 1: 20 V , 2.0 A***
Output 2: 20 V , 2.0 A***
/
Charging time
(approx.)
Battery pack:
2.0 Ah (1 pc)
2.0 Ah (2 pcs)
65 mins
130 mins
/
Machine
Weight
2.9 kg 2.2 kg
**Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal voltage
is 18 volts.
*** Charger output 1 and output 2 mean two ports with
the same output voltage and current.
ACCESSORIES
WG183E WG183E.9
Battery pack (WA3551.1) 2 /
Charger (WA3772) 1 /
Spool (WA0007) 1 1
Spool cap(WA0216) 1 1
Safety guard 1 1
Auxiliary handle 1 1
We recommend that you purchase your accessories
listed in the above list from the same store that sold you
the lawn trimmer. Refer to the accessory packaging for
further details. Store personnel can assist you and offer
advice.
NOISE DATA
A weighted sound pressure L
pA
= 75.8 dB(A)
K
pA
3.0 dB(A)
A weighted sound power L
wA
= 90.2 dB(A)
K
wA
3.0 dB(A)
Wear ear protection.
VIBRATION INFORMATION
Typical weighted vibration a
h
<2.5 m/s
2
Uncertainty K = 1.5 m/s²
The declared vibration total value may be used for
comparing one tool with another, and may also be used in a
preliminary assessment of exposure.
WARNING: The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the tool
is used dependant on the following examples and other
variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and ensuring it is
sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use should
also take account of all parts of the operating cycle such
as the times when the tool is switched off and when it
is running idle but not actually doing the job. This may
significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
To Next Page
Loading...
