To Next Page
Z
zoe67Sep 8, 2025
How to cut high grass with Worx Trimmer?
- SSteve SmithSep 8, 2025
If the grass is too high for your Worx Trimmer, cut it in stages.
How to cut high grass with Worx Trimmer?
If the grass is too high for your Worx Trimmer, cut it in stages.
What to do if Worx WG184E battery was not in use for a long time?
If the Worx Trimmer battery has not been used for a long period or has only been charged for a short time, fully charge the battery. Additional information can be found in the charger manual.
What to do if grass entangled around cutting head of Worx WG184E?
If grass is entangled around the cutting head of your Worx Trimmer, remove the grass.
What to do if plug of Worx WG184E battery charger not plugged in properly?
If the plug of the battery charger for your Worx Trimmer is not plugged in properly, insert the mains plug fully into the socket outlet.
What to do if Worx Trimmer battery is too hot or cold?
If the Worx Trimmer battery is too hot or too cold, allow it to cool or warm.
What to do if socket outlet, mains cable or battery charger defective for Worx WG184E?
If the socket outlet, mains cable, or battery charger for your Worx Trimmer is defective, check the mains voltage and have the battery charger checked by an authorized after-sales service agent.
Wear protective gear, avoid bad weather, and use in daylight or good artificial light.
Disconnect battery before maintenance, use recommended parts, inspect regularly.
Do not dismantle, short-circuit, expose to heat/fire, or subject to mechanical shock.
Dispose of packs separately, recharge only with specified chargers, and observe polarity.
Explains cutting head rotation after switch-off and waiting for it to stop.
Lists issues like non-operation, intermittent running, and provides corrective actions.
General| Power Source | Battery |
|---|---|
| Type | Cordless Grass Trimmer |
| Battery Voltage | 20 V |
| Battery Type | Lithium-ion |
| Cutting Width | 30 cm |
| Line Diameter | 1.65 mm |
| Runtime | Up to 30 minutes |
| Charging Time | 1 hour |
| Line Feed System | Automatic |
| Cutting System | Dual line |
