12
OPERATION INSTRUCTION
NOTE: Before using your tool be sure to read
the instruction manual carefully.
INTENDED USE
The chain saw is intended for sawing of trees, tree
trunks, branches, wooden beams, planks, etc. Cuts can
be sawed with or across the grain. This product is not
suitable for sawing mineral materials.
ASSEMBLY
WARNING! Do not connect the chain saw to
mains before it is completely assembled.
Always use gloves when handling the chain.
CHAIN AND CHAIN BAR ASSEMBLY
1. Unpack all parts carefully.
2. Place the chain saw on a solid, level surface.
3. Use only genuine WORX chains or those
recommended for Guide Bar.
4. Slide the Chain (10) in the slot around the Guide Bar
(9). Ensure the Chain is in correct running direction
by comparing it to the chain icon on the guide bar, or
referring to the Chain Direction Symbol (16) found on
the saw body. Ensure the Bar Tensioning Plate (22) is
facing outwards. (See Fig. A)
5. Fit the Chain onto the Drive Sprocket (15), so that
the Fastening Bar Hole (19) and the two Bar Locating
Tabs (20) on the Bar Pad (18) fit into the keyway of the
opening on the Guide Bar (9). (See Fig. B1, B2)
6. Assure all parts are seated properly. Make sure the
drive links are fully seated in the drive sprocket (See
Fig. C1), avoiding a kink as shown in Fig. C2. If kink
occurs, pick up on the chain at the guide bar just
ahead of the kink and then pull the kink out.
15
To Next Page
Loading...
