Worx WG305E User Manual

When the log is supported on one end, as
illustrated in Figure 4, cut 1/3 the diameter
from the underside (underbuck) (1). Then
make the finished cut by overbucking (2) to
meet the first cut.
When the log is supported on both ends, as
illustrated in Figure 5, cut 1/3 the diameter
from the top (overbuck) (1). Then make the
finished cut by underbucking (2) the lower 2/3
to meet the first cut.
When bucking on a slope always stand on
the uphill side of the log, as illustrated in
Figure 6. When “cutting through”, to maintain
complete control release the cutting pressure
near the end of the cut without relaxing your
grip on the chain saw handles. Don’t let the
chain contact the ground. After completing
the cut, wait for the saw chain to stop before
you move the chain saw. Always stop the
motor before moving from tree to tree.
SYMBOLS
WARNING
Read the manual
Wear eye protection
Wear ear protection
Wear dust mask
Double insulation.
Do not expose to rain
Remove plug from the mains
immediately if the cable is damaged
or cut.
Waste electrical products must not
be disposed of with household
waste. Please recycle where
facilities exist. Check with your local
authorities or retailer for recycling
advice.
3
2
2
W
Y
Z
X
50 mm
50 mm
1
1
1
2
2/3
1
1/3
1
2
2/3
1/3
Figure.1
Figure.2
Figure.3
Figure.4
Figure.5
Fig.VI
3
2
2
W
Y
Z
X
50 mm
50 mm
1
1
1
2
2/3
1
1/3
1
2
2/3
1/3
Figure.1
Figure.2
Figure.3
Figure.4
Figure.5
Fig.VI

Worx WG305E Specifications

General

Brand	Worx
Model	WG305E
Category	Chainsaw
Language	English