14
Cordless Lawn Mower WG730E WG730E.X
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome
if its use is not adequately managed.
WARNING To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off and
when it is running idle but not actually doing the job. This
may significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
4. INTENDED USE
This product is intended for domestic lawn mowing.
5. OPERATION INSTRUCTION
NOTE: Read instruction handbook before
operation this machine.
ASSEMBLY & OPERATION
ACTION FIGURE
ASSEMBLY
Assembling the handle bar See Fig.
A1-A4
Assembling the grass collection
bag
See Fig.
B1-B3
Fitting the grass collection bag to
the lawn mower
NOTE: Depress the grass
collection bag slightly to ensure
that it is completely installed.
See Fig. C1,
C2
Checking the battery charge
condition
NOTE: Fig. D1 only applies for the
battery pack with battery indicator
light.
See Fig. D1
Charging the battery pack
More details can be found in
charger’s manual.
See Fig. D2
Fitting / removing battery
Insert the safety key before
installing the battery pack.
See Fig. E1, E2
OPERATION
Starting & stopping See Fig. F
Adjusting the cutting height
Remove the battery pack. Flip the
mower over. Grip one wheel and
pull or push it forward. Make sure
to pull it forward far enough that it
is able to be move up/down in the
wheel bracket. With the wheel in its
most forward position, slide it up
or down into the desired position.
Repeat the above steps to all four
wheels. Make sure all four wheels
are in the same cutting height.
WARNING! Stop, release
Operating Bail and wait until
the motor stops before adjusting
height. The blades continue
to rotate after the machine is
switched off, a rotating blade can
cause injury. Do not touch rotating
blades.
See Fig. G1,
G2
Grass bag filling indicator
Empty status: flap floats (a)
Fully status: flap falls down (b)
See Fig. H
Removing / emptying grass
collection bag
WARNING! Always check the
safety flap close the discharge
outlet before using. Never lift the
safety flap when the lawn mower
is being used without fitted grass
collection bag.
See Fig. I
Storage See Fig. J1, J2
MOWING TIPS
NOTE: ALWAYS INSPECT AREA WHERE MOWER IS
TO BE USED AND REMOVE ALL STONES, STICKS,
WIRE, METAL AND OTHER DEBRIS WHICH MIGHT
To Next Page
Loading...
Need help?
General
