3. The blade cuts on the upward stroke and may chip
the uppermost surface or edges of your work piece
when cutting, ensure your uppermost surface is a
non-visible surface when your work is finished.
OPERATION:
1. Mark the line of cut, clearly before your cutting.
2. Do not force the tool. Place the steel base (12) firmly
on the workpiece while cutting. Use only enough
steady pressure on the blade to keep the saw
cutting.
3. Reduce the pressure as the blade comes to the end
of the cut.
4. Allow the saw to come to a complete stop when
before removing the blade from the workpiece.
TREE TRIMMING
Use wood blade when cutting tree branches. Cut close
to the branch of the tree to decrease movement of the
branch being cut.
METAL CUTTING
Use a finer tooth blade for ferrous metals and a coarse
tooth blade for non-ferrous metals. When cutting thin
sheet metals always clamp steel on both sides of the
sheet to reduce vibration or tearing of the sheet metal.
Do not force the cutting blade when cutting thin metal
or sheet steel as they are harder materials and will take
longer to cut. Excessive blade force may reduce the
life of the blade or damage the motor. To reduce heat
during metal cutting, add a little lubricant along the
cutting line.
DISPOSAL OF AN EXHAUSTED
BATTERY PACK
To preserve natural resources, please recycle
or dispose of the battery pack properly. This
battery pack contains Lithium batteries. Consult
your local waste authority for information regarding
available recycling and/or disposal options. Discharge
your battery pack by operating your drill, then remove
the battery pack from the drill housing and cover the
battery pack connections with heavy-duty adhesive
tape to prevent short circuit and energy discharge. Do
not attempt to open or remove any of the components.
To Next Page
Loading...
Need help?
General
