Worx WG894E Safety And Operating Manual

9
Cordless Li-Ion handy saw
WG894E WG894E.5
WG894E.9
once before use
The battery charger supplied is matched to the Li-Ion
battery installed in the machine. Do not use another
battery charger.
1. CHARGING YOUR BATTERY PACK
The Li-Ion battery is protected against deep
discharging. When the battery is empty, the machine is
switched off by means of a protective circuit. In a warm
environment or after heavy use, the battery pack may
become too hot to permit charging. Allow time for the
battery to cool down before recharging.
2. TO REMOVE OR INSTALL BATTERY PACK
(See Fig. C)
Depress the battery pack release button to release and
slide the battery pack out from your tool. After recharge,
slide it back into your tool. A simple push and slight
pressure will be sufficient.
OPERATION
1. SAFETY ON/OFF SWITCH (See Fig. D)
Your switch is locked off to prevent accidental starting.
Depress the lock-off button (1) then the on/off switch (5)
and release lock-off button (1). Your switch is now on. To
switch off just release the on/off switch.
2. WORKING INSTRUCTIONS
NOTE: Hold the machine away from yourself. Stand in
a secure and stable position.
WARNING: Always clamp and support
workpiece securely. Do not touch blade
to workpiece until saw reaches full operating
speed.
HOW TO GRASP YOUR WORX HANDY SAW
Grasp your WORX Handy saw as shown in Fig E,
for best control of the tool and comfortable use as a
reciprocating saw.
GENERAL CUTTING (See Fig. F1, F2)
NOTE:
1. Always use a blade suited to the material and
material thickness to be cut. The quality of cut will
improve as the number of blade teeth increase.
2. Always ensure the workpiece is firmly held or
clamped to prevent movement. Support large panels
close to the cut line. Any movement of the material
may affect the quality of the cut.
1
2
1
2’
2
6
9
B
C
D
A
F1
F2
E

Worx WG894E Specifications

General

Brand	Worx
Model	WG894E
Category	Saw
Language	English