Mini-circular saw WX420
13
location where the blade will plunge into the work
piece, based on the blade depth that was selected.
Always practice in a scrap work piece to become
familiar with this cutting operation. The selected depth
of cut is now set. When the saw’s blade is manually
lowered, the blade will be below the base at the
selected depth.
3. USING THE LASER
The laser is used as a cutting guide and should form a
red line on the material surface that is exactly aligned
with the blade alignment indicator (12).
Press down the laser on/off switch (5) to turn on the laser.
Press down the laser on/off switch again to turn off the
laser. (See Fig. I)
NOTE: Clean the laser generator periodically.
WARNING: Never stare directly into the laser
beam and never point the beam at anybody. The
laser beam energy is extremely harmful to human
eyes.
WARNING: When not in use, always turn the
laser off to save the battery capacity.
TO REPLACE LASER BATTERIES (See Fig. J1-J6)
The saw comes with laser batteries well assembled. When
battery capacity runs out, replace batteries as follows:
Use 1.5V batteries model LR44, typical to calculators,
cameras and similar small electronics.
Move the battery storage cover (16) in the direction the
arrow (on the cover) points. Then lift the battery storage
cover (See Fig. J1, J2).
You can see one end of a cord. To remove the batteries,
just slowly pull the end of the cord. The two batteries
will be taken out along with the cord (See Fig. J3).
To fit new batteries, adjust the position of the cord and
insert two batteries in place. Make sure two batteries
are pressed on the cord (See Fig. J4, J5).
Restore the cover (See Fig. J6).
NOTE: Pay attention that “+/-” of the batteries are the
same as the illustration on the machine.
4. CUTTING GUIDE (See Fig. K)
The blade alignment indicator (12) in the front of the
base plate is used as a cutting guide. Always guide
it along the cutting mark made on the workpiece for
accurate cutting.
NOTE: It is best to carry out a trial cut.
To Next Page
Loading...
