Mini-circular saw WX420
15
firmly before switching on the saw. Switch the saw
on, wait for it to reach full speed, and gently guide the
blade down into the material but maintain a pivoting
force on the front edge of the base. Watch your cutting
line by carefully looking through the front end of the
blade slot.
DO NOT bind the blade in the cut; push the saw blade
forward at a rate where the blade is not laboring.
When the cut is complete, release the trigger safety
release and switch and let the blade come to a
complete stop. DO NOT REMOVE the saw and blade
from the workpiece while the blade is moving. This
could damage your cut (kerf), cause kickback and loss
of control, resulting in injury.
WorKinG hinTS for your Tool
If your Versacut
TM
becomes too hot, please run your
Versacut
TM
no load for 2-3 minutes to cool the motor.
Avoid prolonged usage under strenuous cutting loads.
Protect saw blades against impact and shock. Excessive
feed significantly reduces the performance capability
of the machine and reduces the service life of the saw
blade. Sawing performance and cutting quality depend
essentially on the condition and the tooth count of the
saw blade. Therefore, use only sharp saw blades that
are suited for the material to be worked.
Choice of blades: 24 teeth for general work, approx. 40
teeth for finer cuts, more than 40 teeth for very fine cuts
into delicate surfaces, diamond for tile, cement board,
etc.
MainTain ToolS WiTh care
Remove the plug from the socket before carrying
out any adjustment, servicing or maintenance.
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and
changing accessories. Inspect tool cords periodically
and if damaged, have repaired by authorized service
facility. Your power tool requires no additional
lubrication or maintenance. There are no user
serviceable parts in your power tool. Never use water
or chemical cleaners to clean your power tool. Wipe
clean with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust.
If the supply cord is damaged, it must be replaced by
To Next Page
Loading...
