WPG P1HV1102DC3 - Powering up the Lifter; Sealing the Pads on the Load

To Next Page

To Previous Page

Rev 2.2/12-21 P1-02DC3: #3512215

Powering up the Lifter

Press the lifter's power button ( — fig. 1A). The

vacuum pump

will run for a few seconds, as a

normal function of the Intelli-Grip

self-diagnostics.

The lifter automatically tests the 9-volt battery for

the

notification buzzer

each time the lifter is

powered up. When this battery runs down, the

LCD screen

displays “Replace 9V battery?” and the

buzzer chirps once per minute. Replace the battery

as needed (see “N

OTIFICATION BUZZER BATTERY

EPLACEMENT”).

To use the optional Remote Control System, briefly hold the

power button

( — fig. 1B) on the radio transmitter to

activate it.

Note: When you hold any button on the transmitter, the

transmission indicator light

flashes green if the transmitter is

activated.

Sealing the Pads on the Load

Press the lifter’s “attach” button ( — fig. 1

Keep “attach” function

activated throughout lift.

1..... The radio transmitter turns off automatically after a period of inactivity.

OPERATION