WPG P1HV1102DC3 - Storing the Lifter; Transporting the Lifter

To Next Page

To Previous Page

Rev 2.2/12-21 P1-02DC3: #3512223

Storing the Lifter

Use the covers supplied to keep the vacuum pads clean

(fig. 1A).

CE/UKCA -- To prevent the lifter from tipping over on

relatively horizontal surfaces, place the vacuum pads facedown

on a clean, smooth, flat surface. Then lower the

lift bar

and

place a support under the lift point

2) Charge the battery

completely and repeat every 6 months (see “12-VOLT BATTERY

ECHARGE”).

Disconnect the electrical connectors (figs. 3A-B

and figs. 3C-E) to prevent battery

discharge.

4) Store the lifter in a clean, dry location.

Store the battery between 32° and 70° F [0°വ21°

C]. Avoid storage above 100° F [38° C].

Transporting the Lifter

Secure the lifter in the original shipping container with the original shipping materials or

equivalent.

OPERATION