wtw pH 3110 - Resetting All Meter Settings

pH 3110 Operation
35
ba75791e02 11/2008
4.6.2 Resetting all meter settings
This function resets all meter settings to the default condition. The
relevant values are given in the following sections:
Resetting the meter
settings
Note
The measuring system is not calibrated after a reset. Before
measuring, recalibrate the meter.
System settings section 4.5.1
Measurement settings section 4.5.2
1 Switch on the meter with <On/Off>.
The display test appears briefly on the display.
2 During the display test, press <M> to open the menu for the
reset of the meter settings.
Init is displayed.
3 Press <▲><▼> to display no or YES.
YES: Reset the meter settings.
no: Retain the meter settings.
4 Confirm with <ENTER>.
The menu is finished.
The meter switches to the measuring mode.
o
n
t
i
n
I