Turb 2000 Series Operation
ba75695e03 10/2013 17
The security code (333) must be entered to gain access to CAL or CONFIG menus. Notice that the first
number in the code is flashing; the flashing indicates that this is the number to be changed. Use the
or
arrows to select the first of the three numbers in the code and then press the OK button to accept
the first number of the code. Now enter the second number in the code. Proceed as with the first
number followed by OK. Then repeat the process for the third number in the access code, and finish
with the OK button.
If the valid access code has been selected, the instrument will be directed to the calibration mode. If the
wrong access code is selected, the instrument will return to the AUTO mode. Refer to section 6.7
E
NABLING THE SECURITY ACCESS for more information.
To Next Page
Loading...
