Wulfsberg FLEXCOMM 2000 - Page 12

FLEXCOMM 2000
TRANSCEIVER SYSTEMS
(P-2000 AND C-2000/RT-2000)
INSTALLATION MANUAL
Page viii Publication No. 150-049106
Table of Contents Rev. F
Nov 2007
TABLE OF CONTENTS (Cont’d)
Section
Page
Section 3 – ELECTRICAL INSTALLATION
1. General Information..............................................................................................................35
2. Installation Wiring Diagrams.................................................................................................36
3. Connector Pin Number and Descriptions .............................................................................43
4. Pin – Signal Name (J101 25 Pin D-sub)...............................................................................44
5. Pin – Signal Name................................................................................................................47
Section 4 –INSTALLATION CHECKOUT PROCEDURE
1. Introduction ...........................................................................................................................51
2. Procedure .............................................................................................................................51
Section 5 –CONTINUED AIRWORTHINESS INSTRUCTIONS
1. Introduction ..........................................................................................................................53
2. Equipment ............................................................................................................................53
3. Antenna Verification .............................................................................................................53
A. Transmitter Verification...............................................................................................53
B. Receiver Verification ...................................................................................................54
C. Final System Check-out..............................................................................................54
Section 6 –CONFIGURATION PROCEDURES
1. Introduction ..........................................................................................................................55
2. Configuration Settings .........................................................................................................55
A. Mic Mode (Dual/Single)...............................................................................................55
B. Lock Volume (No/Yes)................................................................................................55
These commodities, technology or software are controlled in accordance with the United States Export Administration Regulations, Export Classification
Control Number (ECCN) 7E994. When exporting, diversion contrary to U.S. law is prohibited.