FLEXCOMM 2000
(P-2000/C-2000/RT-2000)
Installation Manual
Page 2 of 56 Publication No. 150-049106
P-2000 Installation Manual Rev. F
Nov 2007
The P-2000 is designed to be drop-in replacement for the C-962A/S Control unit for the Wulfsberg
RT-9600/7200 transceiver systems also known as the ARC-513 with the exception of the 28 Volt
input power. Due to increased 28 power requirements of the P-2000, wire size on this input may
need to be increased to 20 AWG. All other microphone inputs/headset outputs and backliting are
compatible.
B. C-2000 Control Display Unit
The Wulfsberg C-2000 is a control display unit that can be used as a slave control head with a P-
2000 panel mount transceiver, or as a primary or slave control head for the RT- 2000 remote
transceiver. Versions of the C-2000 include black faceplate and options for either Standard or NVG
compatible displays. Input voltage is 28 volts DC and the keypad is backlit from either 28 Vdc, 5 Vdc
or 5 VRMS.
The C-2000 Control Display Unit is designed to be mounted in the instrument panel that will fit a
standard DZUS mounting. Two connectors, a DB-25 and DB-15, accept all harness wiring on the
rear of the P-2000.
Front panel controls establish and display the operating status of all RT-2000 or P-2000 functions
when operating as a slave control unit.
C. RT-2000 Remote Mount FM Communications Transceiver
The Wulfsberg RT-2000 is a FM Tactical transceiver that incorporates one or two transceiver
modules and control functions into a single panel mount unit. Part number variations of the unit exist
for any combination of the following frequency bands: 137-174 MHz, 380-470 MHz, 403-470 MHz,
450-520 MHz, 764-870 MHz and 806-870 MHz. Each transceiver module with the exception of the
764-870 MHz and 806-870 MHz band can transmit with 1 or 10 Watts transmit power. The 800 MHz
units produce 1 and 2.75 watts transmit power. The RT-2000 is designed to be controlled by a C-
2000 control display. Input voltage is 28 volts DC and the keypad is backlit from either 28 Vdc, 5 Vdc
or 5 VRMS AC.
The RT-2000 transceiver is designed to be rack mounted. Two connectors, a DB-25 and DB-15
accept all harness wiring on the rear of the RT-2000, while two TNC type RF connector provides the
antenna connection through conventional coaxial cables. For models containing one transceiver,
only one antenna port is provided.
The RT-2000 consists of functional subassemblies interconnected via standard connectors and
ribbon cables. The case of the RT-2000 is designed to be easily disassembled to expose most
subassemblies or circuit modules for service. All adjustments to audio levels can be made via
software and do not require the disassembly of the box. Internal test points are exposed and
available to the service technician without having to remove circuit module subassemblies or use
extender cables or cards.
The RT-2000 is designed to fit into a rack space equivalent with the Wulfsberg RT-9600 with the
exception of depth. The RT-2000 is only approximately 7 inches deep vs. the nearly 14 inch depth of
the RT-9600.
These commodities, technology or software are controlled in accordance with the United States Export Administration Regulations, Export Classification
Control Number (ECCN) 7E994. When exporting, diversion contrary to U.S. law is prohibited.
To Next Page
Loading...