WÜRGES HV - Page 77

77
HF 6000 min
-1
, 200 Hz, 3000 min
-1
200 Hz
Motor
Reduced Fore
HF 2
880 N
HF 6/4
1525 N
HF 6/8
380 N
HF 8
1525 N
HF 15
2400 N
After the centrifugal force has been set, the motor shaft, in the case of motors
with ball bearings, must be checked for ease of movement. If the shaft is stiff,
you should hit the last tightened screw, lightly with a mallet to loosen the tension
of the ball bearings.
Maximum tightening torques for the screws at the shaft end
HV 0,4/2
M5
4 Nm
HV 1
M5
4 Nm
HV 2
M 8
15 Nm
Ab HV 6
M10
20 Nm