9
Preparing the Trailer for Cold Weather
The “Express” Hot Pressure Washer Trailer must be pro-
tected from freezing.
Drain the tank by removing the plug from the Tee beneath
the tank. Treat the plug with thread sealant and replace
the plug when the tank is empty.
The pressure washer must have an anti-freeze solution
circulated throughout the washer by one of two options.
RV anti-freeze is a recommended solution.
(1) Pour a couple of gallons of anti-freeze solution in the
empty tank. Open the tank valve. Remove the spray tip,
start the pressure washer, open the spray gun and run until
antifreeze runs out of the end of the gun.
(2) With the main tank empty, attach a short hose to the
garden hose tting, insert the hose into a container of
anti-freeze solution. Close the tank valve and open the ll
valve. Remove the spray tip, start the pressure washer,
open the spray gun and run until antifreeze runs out of the
end of the gun.
Maintenance
Cleaning the Strainer
The “Express” Hot Pressure Washer Trailer is equipped
with a “T” strainer to lter foreign matter from the water.
From time to time it may be necessary to clean the strainer.
Close the tank valve and ll valve to isolate the strainer.
Unscrew the strainer bowl. Be sure to account for the O-
ring. Remove the strainer screen and clean. Reinstall the
screen and bowl. Make sure the O-ring is not pinched or
lost when installing the bowl. Open the tank valve to restore
water ow.
Figure C2
Cleaning the Strainer
Figure C4
Winterizing the Pressure Washer
Figure C3
Draining the Tank
Rubber Plug >
Figure C1
Wheel With Accu-Lube Hub
Maintenance
< Closed Tank
Valve
< Closed Fill
Valve
< Strainer Bowl
< O-Ring
Strainer Screen >
< Closed Tank
Valve
Open Fill >
Valve
< Short Hose
< Anti-freeze solution
Plug >
Tee >
Tank >
To Next Page
Loading...
