3
Safety Issues
• Inspect trailer for wear or damage.
• Ensure that all fasteners and ttings are tight.
• Flush tank and pump with fresh water if chemicals are used. Dispose of ush water using
appropriate means.
• Carry out maintenance and/or lubrication procedures as outlined in this manual.
• Keep hands, feet and clothing away from moving parts and the spray pattern.
• Wear protective clothing and gloves when working with chemicals.
• Assure that the hitch is attached to the proper size ball.
• Attach the safety chains and breakaway brake cable to the tow vehicle.
• Plug the lights into the tow vehicle.
• Do not permit others to ride on the trailer.
• Operate tow vehicle smoothly – no jerky turns, starts and stops.
• Hitch only to the hitch points recommended by the tow vehicle manufacturer.
• When tow vehicle is idle, engage brakes and park lock securely.
• Tighten lug bolts before transporting the rst time and maintain proper torque.
• Check lights and wiring daily. Service and replace to maintain proper operation.
After Use
Always
Operator’s Instructions
Wylie Manufacturing, 702 E. 40th St., Lubbock, TX 79404
Reporting Safety Defects
If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should
immediately inform the National Highway Trac Safety Administration (NHTSA) in addition to notifying Wylie
Manufacturing.
If NHTSA receives similar complaints, it may open an investigation, and if it nds that a safety defect exists in a
group of vehicles, it may order a recall and remedy campaign. However, NHTSA cannot become involved in indi-
vidual problems between you, your dealer, or Wylie Manufacturing.
To contact NHTSA you may either call the Auto Safey Hotline toll-free at 1-888-327-4236 (TTY: 1-800-424-9153);
go to http://www.safercar.gov; or write to:
NHTSA
U. S. Department of Transportation
12000 New Jersey SE
Washington, DC 20590
You can also obtain other information about motor vehicle safety from the http://www.safercar.gov.
To Next Page
Loading...
