Wylie Express - Maintenance, Lubrication

8
The pressure washer can be supplied from either the main
tank or from a garden hose.
Supplying from Tank
Open the tank valve and close the ll valve.
Supplying from Hose
Attach the hose to the ll valve tting. Close the tank valve
and open the ll valve.
The Pressure Pro 3500 pressure washer is equipped
with its own operating manual. The manual is located
in the same storage sleeve as this manual. Refer to the
supplied manual for detailed operating instructions for the
pressure washer.
The pressure washer manual will include instructions on
safety procedures, the engine and heater fuel systems,
procedures for applying soap, and the proper way to man-
age the water pressure and hot water.
Operation -- “Express”
Follow all safety and operating instructions to ensure a safe
and e󰀨ective workplace.
Figure B6
Operating Pressure Washer
Figure B5
Valve Setting for Supplying Pressure Washer from Hose
Do not point the spray gun at any person, animal
or body part. Never put your hand, ngers or body
directly in front of the spray nozzle. The pressure
washer generates up to 4,000 psi with water
temperature up to 200º F.
Serious injury or death could result.
Lubrication
Check the engine owner’s manual for the proper oil to add
to the engine.
Some models are equipped with Accu-Lube hubs. If your
trailer is equipped with the Accu-Lube system remove the
rubber plug and place grease gun (no air powered grease
guns) onto the zerk. Pump in new grease until you see the
old grease owing back out of the cap. Wipe o󰀨 old grease
with a towel. Be sure to re-install rubber plug. Service
every 12 months or 12,000 miles. Service more often in
extremely dusty and/or wet conditions.
Standard hubs should be packed once a year or more
often in severe conditions.
< Open Tank
Valve
Closed Fill Valve >
Figure B4
Valve Setting for Supplying Pressure Washer from Tank
< Closed Tank Valve
Open Fill Valve >
< Supply Hose