10
Button Control
Users can perform basic switching of input sources to output
displays using front panel buttons.
To select an input source for the output display:
1. Press one or multiple buttons of OUT 1-4 to select output
port(s). The LED will light up once specific output port is
selected.
2. Press one button of IN 1-4 to select an input port. The LED
will light up one specic input port is selected.
3. Press the ENTER button to implement the selection. The
selection takes effect when the LEDs are off.
IR Control
The device can be controlled by the IR remote controller.
Connect the IR receiver cable to the IR EXT. port at the rear
panel of the device and ensure the receiver eye is accessible to
the remote controller.
Select previous input
for Output 1
Select next input
for Output 1
Output 1
Select specic input
for Output 1
To select an input source for one output display:
To Next Page
Loading...
