20
CEC Control
• Display On: Click to power on the display connected to the
output selected.
• Display Off: Click to power off the display connected to the
output selected.
• Auto On/Off: Select to enable or disable CEC Auto Control.
Default setting: Off
• Auto Delay Time (1~30min): Click the up/down arrow to set
the time for the display to power off automatically when no
signal is present. For example, if the time is set to 2 minutes,
the output display will power off automatically when there’s
no signal at the display for 2 minutes.
HDCP
This section allows you to enable or disable HDCP encryption of
each input port.
• On: Select to enable HDCP encryption for the selected input
port.
• Off: Select to disable HDCP encryption for the selected input
port.
Default setting: On
To Next Page
Loading...
