Operation
3-12 975-0057-01-01
8. Remove the red positive (+) clip and then the black
negative (–) clip from the vehicle’s battery terminal.
9. Remove the cables from the Jump-Start Cable Port.
Using the Air Compressor: XPower
Powerpack 400 Plus
WARNING: Fire hazard
The jump-start feature is designed for short term
operation only—less than 4 seconds. Operating the
jump-start feature for more than 4 seconds may
cause damage to the unit. Allow the XPower
Powerpack to cool down for at least 3 minutes after
each jump-start.
Important: Recharge the XPower Powerpack as soon as
possible after each use. See “Recharging the XPower
Powerpack Battery” on page 4–2.
WARNING: Fire Hazard
The compressor is designed for short term
operation only.
Operating the compressor over an extended period
of time will cause the compressor unit to overheat
which could lead to fire. Allow the compressor to
cool down for 10 minutes after each 10 minutes of
continuous operation.
To Next Page
Loading...
Need help?
General
