Replacing the Incandescent Light
975-0057-01-01 4-11
7. On the XPower Powerpack, replace the battery cover and
the four fasteners.
8. Dispose of the old battery in an environmentally
responsible manner.
Replacing the Incandescent Light
To replace a light bulb:
1. Turn the light switch off.
2. Unscrew the cover and lens.
3. Gently grasp the bulb and pull to remove the light
reflector assembly and the bulb.
4. While holding the light reflector assembly, gently
unscrew the black knob at the back of the assembly.
5. Remove the old bulb and insert a replacement bulb of the
same type and rating into the light reflector assembly.
6. Holding the light reflector assembly, gently screw the
black knob on to the back of the assembly.
7. Reattach the lens and cover.
Replacing the External Fuse
The replacement fuse must be rated at 250 A, 32 V DC. See
page 2–7 for a diagram. To replace the external fuse:
1. Remove the fuse cover.
2. Unscrew the two bolts on the fuse.
3. Replace the fuse. Ensure that the replacement fuse is
rated at 250 A, 32 V DC and is of the same type.
4. Tighten the fuse with the two bolts.
5. Replace the fuse cover.
To Next Page
Loading...
Need help?
General
