EasyManuals Logo

Xantrex 200 User Manual

Xantrex 200
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #49 background imageLoading...
Page #49 background image
Recharging the XPower Powerpack Battery
975-0057-01-01 4-3
Recharging with the AC Charger
Recharging with the AC Charger is a true “plug-in-and-
forget” charging method.
To recharge with the AC Charger:
1. Disconnect any 12 V DC appliance and turn the light
switch to Off.
2. Turn the AC Outlet On/Off switch to Off.
3. Plug the AC Charger into a standard AC wall outlet.
4. Insert the AC Charger cable end into the Charger Input
Socket located in the charger storage compartment.
5. While the XPower Powerpack is recharging, the green
Charging Status light is flashing. If the battery is
completely discharged, a typical recharge may take up to
35 hours. When fully charged, the green Charging
Status light changes to steady and the XPower
Powerpack is ready to use.
CAUTION
Do not operate AC or DC appliances while the
XPower Powerpack is being recharged with the AC
Charger.
The AC Charger may be permanently damaged if
AC appliances or 12 V DC appliances are operated
while the AC Charger is connected.
Important: The 35-hour charging time for the XPower
Powerpack assumes that there is 120 V at the AC wall
outlet. If the voltage is less than 120 V AC, it may take more
than 35 hours to fully recharge the XPower Powerpack. If,
after 35 hours of charging, the green Charging Status light
is still flashing and not steady, continue to charge the unit
for another 15 hours.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xantrex 200 and is the answer not in the manual?

Xantrex 200 Specifications

General IconGeneral
BrandXantrex
Model200
CategoryPower Pack
LanguageEnglish

Related product manuals