What to do if Xantrex Portable Generator exceeded max number of start tries?
If the Auto Gen Start has tried and failed to start the generator, and to prevent draining the start battery, it has suspended further start attempts, check the generator’s fuel level and start battery condition. Consult the generator manual and clear the fault on the System Control Panel screen to allow a retry.
What to do if Xantrex Automatic Generator is unable to stop?
If the Auto Gen Start has lost contact with the generator or the generator did not stop after the Auto Gen Start sent it a stop signal, change the Auto Gen Start mode to Manual Off. If this fails to work, stop the generator with the external stop switch. Check the generator and return the Auto Gen Start to automatic mode to resume automatic starts and stops.
What to do if Xantrex Portable Generator was stopped by external sensor?
If an external sensor connected to the Auto Gen Start has stopped the generator and put the Auto Gen Start into Manual Off mode, clear the fault and reset the Auto Gen Start to the desired mode after the sensor connected to the external shutdown has deactivated.
What to do if Xantrex Portable Generator was started by its switch?
If the generator was started, but not by the Auto Gen Start, check your generator and stop it using the switch or control panel on the generator.
What to do if Xantrex Portable Generator stopped externally?
If the generator has stopped, but not by the Auto Gen Start because it may have run out of gas, or may have been shut off by a switch on the generator, check the generator’s fuel level and mechanical condition, then start the generator manually (using the switch or control panel on the generator) to clear the warning.
What to do if Xantrex Automatic Generator is unable to start?
If the Auto Gen Start tried, but could not start the generator, no action is required. The Auto Gen Start will try to start the generator again until it reaches the maximum number of start tries.
Why Xantrex Automatic Generator Portable Generator auto triggers not enabled?
If you are attempting to enter Automatic Mode without setting Auto triggers, acknowledge the warning and set a start and stop trigger.
What to do if Xantrex Automatic Generator Portable Generator mismatched triggers?
If you have set a stop trigger, but not a corresponding start trigger, acknowledge warning and set a start trigger.
What to do if Xantrex Automatic Generator max generator run time reached?
If the generator has run for its maximum allowable time and the Auto Gen Start has stopped the generator and changed the AGS Mode to ManualOff, acknowledge the warning. Return the Auto Gen Start to the desired AGS Mode (Automatic or ManualOn). Ensure the generator is fueled and is supplying required power for battery charging and loads.
What to do if Xantrex Portable Generator max generator cycles reached?
If the generator has reached its maximum number of start-and-stop cycles and to help prevent an unattended generator from starting, the Auto Gen Start changed the AGS Mode to ManualOff, acknowledge the warning. Return the Auto Gen Start to the desired AGS Mode (Automatic or ManualOn). Ensure the generator is fueled and is supplying required power for battery charging and loads.
General safety guidelines and precautions for using the Auto Gen Start.
Precautions related to explosive gases and FCC compliance.
Steps for planning and gathering tools/materials for installation.
Procedures for mounting the unit and making external connections.
Understanding and responding to fault and warning messages displayed by the Auto Gen Start.
List and explanation of common warning messages and their causes/actions.
List and explanation of fault messages, their causes, and required actions.
General| Brand | Xantrex |
|---|---|
| Model | Automatic Generator |
| Category | Portable Generator |
| Language | English |
To Next Page