Installing Truecharge+
2–2
Materials List
Contents The unit is packed with the following materials:
• Owner’s Guide
• Wiring cover with 2 blunt-tip screws and two lock washers
• AC cable clamp
• Three twist-on wire nuts
• Three crimp-on butt-splices
Recording
information
After unpacking the unit, record the serial number and other purchase
information on page D–7 of this guide.
Preparing for Installation
Mounting Truecharge+ is designed to be permanently mounted. It is virtually
maintenance free when properly installed.
Conditions Before mounting and connecting Truecharge+, be sure you meet the
requirements for
•location
•circuits
• wiring
• tools and materials
Figure 2-1 Truecharge 20+ (left) and Truecharge 40+ (right)
To Next Page
Loading...
