Xerox 128 - Clearing the Q1205, Q1206, and Q1207 Sensors

3-44 DocuTech 128/155/180 HighLight Color Operator Guide
Routine maintenance
Figure 3-41 Locating the Q1222 and Q1210 sensors
4. Wipe each sensor gently with a soft cloth to clean them.
5. Close the finisher top cover.
Clearing the Q1205, Q1206, and Q1207 sensors
NOTE: Production publisher configuration only
Clearing the Q1205, Q1206, and Q1207 sensors should be
performed only when directed by a Customer Support Center
Representative.
1. Open the finisher front doors.
2. Open the bindexer door.
3. Locate the Q1205, Q1206, and Q1207 sensors, as shown in
figure 3-42.