Safety Instructions
Xerox 8254E / 8264E Color Wide Format Printer
User Guide
1-6
• When cleaning around the 8264E print head only:
– Do not touch the print head itself. Doing so may damage the print head.
– Do not touch the head of the cleaning stick with your fingers. Oil on your hands may get on the
cleaning stick, causing damage to the print head.
– Do not immerse the head of the cleaning stick in water. A wet cleaning stick may damage the
print head.
– Do not re-use the cleaning stick. Dust attached to the cleaning stick may damage the print
head.
• Do not lean the printer, prop it against a wall, or turn it upside down. There is a possibility that ink
inside the printer may leak. Moreover, normal operation after shifting to these positions cannot be
guaranteed.
• For safety reasons, if you are not going to use the printer for a long period, make sure to disconnect
the power supply cable from the building’s electrical outlet.
• Make sure to connect a ground wire to a ground connection that meets the following standards:
– Use only electrical outlets that are connected to a ground.
– The ground wire should be attached to a copper plate which is buried in the ground to a depth
of 650mm (25") or more.
• Keep the work area well-ventilated. This prevents fire, and prevents operators from feeling sick from
fumes.
• When printing is finished, the media guide is hot. Wait until the media guide cools off before
touching it.
• Pay attention to the following points when you cut roll media. Mishandling the razor blade may
cause a cut on your finger or hand.
– When you hold the media, do not place your finger on the media cut groove.
– Move the razor blade along the media cut groove.
• When cleaning the printer, be sure to first press the printer’s [Power] key to turn it OFF and
disconnect the power supply cable(s) from the building’s electrical outlet.
• Whenever you move the printer, keep it in an upright, horizontal position.
To Next Page
Loading...
Need help?
General
