Preparing For A Job
Xerox 8254E / 8264E Color Wide Format Printer
User Guide
3-3
WARNINGS:
• Do not connect or disconnect a power cable with a wet hand. This could lead to an electric shock.
• Make sure to use only the power supply specified for your printer (AC 100 V - 120 V or AC 220 V -
240 V). If a power supply with other than the specified voltage is used, it could cause an electric
shock and fire.
• Plug the printer directly into the building’s electrical outlet (AC 100 V - 120 V or AC 220 V - 240 V).
Do not use multiple power cables on the same electrical outlet. This could generate heat and might
cause fire.
• For the power supply, make sure to use a dedicated electrical outlet with a ground terminal,
connected to a ground. If the ground wire is not connected, an electric shock or fire may occur.
• Do not connect a ground wire to the following places.
• Gas pipe
There is a possibility of ignition and explosion.
• Ground wire of telephone cables and lightning rods
Heavy current might flow whenever lightning strikes.
• Water pipe and faucet
The ground might not work if a plastic pipe is connected in the middle of the metal pipe.
• Pay attention to the following points when handling any power cable. Any mishandling of a power
cable could cause a fire.
• Make sure that no foreign substances such as dust, etc. are stuck to the power cable’s plug.
• Make sure that the power cable’s plug is firmly and completely inserted into the building’s
electrical outlet.
• For safety, if you do not plan to use the printer for a long period, make sure to disconnect the power
cable(s) from the electrical outlet.
• Make sure to connect a ground wire to a ground connection that meets the following standards.
• Use only building electrical outlets that are connected to a ground.
• The ground wire should be attached to a copper plate which is buried in the ground to a
depth of 650mm (25").
To Next Page
Loading...
Need help?
General
