XES Synergix 8825/8830/8850/8855 & X2-TECH System Introduction 9
System Capabilities (continued)
Optional On-line Folders
The folder is an optional finishing device which can be used with the XES
Synergix 8825/8830/8850/8855 Engineering Printer or Digital Solution. The
default finishing options are controlled from your workstation by using the
Web PMT or the AccXES Client Tools. You may be offered a limited
selection of folding options, or a full selection of finishing programs to choose
from, depending upon your attached folding device. All available options will
be displayed on the Web PMT’s Finishing Page, which is located by selecting
Printer Defaults, then Processing Defaults, then Finishing. In the AccXES
Client Tools, select the finishing options by going to the Document Submit
Tab, then the Job Options toolbar button, then the Finishing Tab.
NOTE: The X2-TECH Digital Solution does not support folding (finishing)
at this time.
Figure 5. Typical Finishing Page of the Web PMT.
To Next Page
Loading...
Need help?
General