XES Synergix 8825/8830/8850/8855 & X2-TECH System Introduction 50
Controller Error Codes
The Controller firmware supports the printing of the Error Code Log as part of
the information contained in the CONFIGURATION Test Print. The
information is displayed in the following format.
ERROR LOG:
(NNNNNNNN,CCCCCCCCCC
Where:
NNNNNNNN is a decimal number representing the number of seconds the
Controller has been powered on and running.
CCCCCCCC represents the error code.
The first (NNNNNNNN,CCCCCCCC) pair displayed contains the total number
of seconds the Controller has been powered on and running and an error
code of 00000000. A maximum of 19 additional (NNNNNNNN,CCCCCCCC)
pairs are displayed. The number of seconds of power-on time displayed in
the additional pairs is the time at which the error occurred. The additional
pairs are displayed in order from most recent to oldest error. Restoring
Factory Defaults will clear the error codes from the log. Loading a new
release of firmware on the Controller will also clear the error codes from the
log. The total number of seconds of power-on time value is not cleared by
restoring Factory Defaults.
Instructions for restoring factory defaults, are provided in the XES Synergix
8825/8830/8850 Controller Setup Manual for Firmware 8.0, or in the Web
Printer Manager Tool User Guide (for firmware version 8.0).
For full firmware uploading instructions see the Firmware Release Notes that
accompany all firmware releases (on CD or the Internet at www.xes.com).
To Next Page
Loading...
Need help?
General